Found it cheaper? We will make an offer better
Segmented single beam bending machine for the manufacture of front cassettes, boxes, casings, etc.
- Model:Сегментированный листогиб 2020х1.2мм
- Available:In stock999
- Weight:640.00 kg
- Dimensions (L х W х H):2,470.00 x 940.00 x 1,320.00 mm
- Show all attributes
- The machine is supplied with an upper clamping segment beam
- PBB 1520 / 1.5 machine has 13 segments of different sizes: 25 mm, 30 mm, 35 mm, 40 mm, 45 mm, 50 mm, 75 mm, 100 mm, 150 mm, 200 mm, 250 mm, 250 mm, 270 mm. Bending beam width 15 mm. The lifting height of the clamping segment beam is 47 mm. Depressed height without segment 25 mm.
- Machine without limiting the depth of sheet feeding
- Foot drive allows the operator to quickly rotate and move workpieces
- Steel construction guarantees the necessary rigidity and stability of the machine during daily use
- The design of the machine has a vertical stroke of the clamping beam, which allows fixing workpieces with strictly parallel surfaces and a stronger clamp along the entire length of the machine, in comparison with conventional axial clamps.
- Bending beam spring system facilitates the operator's work on the machine
- When working with max. sheet thickness - the maximum parameters may not correspond to the table values, this is due to the difference in the ultimate strength coefficient σв, which should not exceed the σв <400 MPa parameter when working with low-carbon and carbon steel.
- For materials other than carbon steels (such as alloy steels, stainless steels, cold rolled steels), consult with the sales company.
Bending machine Stalex PBB series is designed for the manufacture of various products from sheet materials with wide and complex shapes. With flexible products on four sides such as boxes, pallets, ventilated facades and any other profile metal products.
Max. working length
Max. sheet thickness (σw <400 MPa)
Max. lifting height of the pressure beam
Net / gross weight
When working with max. sheet thickness - the maximum parameters may not correspond to the tabular values, this is due to the difference in the ultimate strength coefficient σв, which should not exceed the σв <400 MPa parameter when working with low-carbon and carbon steel.
For materials other than carbon steels (such as alloy steels, stainless steels, cold rolled steels), consult with the sales company.
Photo of nodes:
The warranty for equipment and accessories is 1 year.
We deliver equipment throughout Russia and the CIS!
|Segmented bending machine (2 segment beams)|
|Bending length, mm||2020 mm|
|Sheet thickness, steel (σw <400 MPa), mm||1.2 mm|
|Segmental bending beam||Yes|
|Bend angle, degrees||135 degrees|
|Dimensions LxWxH, mm||2470x940x1320 mm|
|Weight, kg||490/640 kg|