Bending machine manual segment Stalex W2.5x2540A

Stalex segmental benders are designed for use in the workshop. They can be used for the production of pallets, ventilation pipes, as well as standard additional elements. The eccentric clamping system allows you to clamp the material as quickly as possible.

Stalex W2.5 machines with a length of 2040 mm the clamping segment beam has the following segment sizes: 76, 104, 127, 153, 280.

Stalex W2.5 machines with a length of 2540 mm the clamping segment beam has the following segment sizes: 63, 76, 89, 102, 127, 152, 305.

Each segment consists of 2 parts, which provides additional rigidity and a tighter hold. The maximum lifting height of the pressure beam is 30 mm.

The bending beam is equipped with an adjustable counterweight system to facilitate bending of different thicknesses of metal. A reinforcing angle 50 mm wide is installed on the bending bar.

Features:

1. Unlimited feed depth

2. Adjustable bars for precise adjustment of the bar deflections:

- Bending beam regulating rods

- Rods regulating the pressure beam

3. Steel bed for machine rigidity

4. 135 degree bending capability

5. Angle stop as standard

6. Counterweight system for easy bending

7. Upper segment blade with different segment width

8. Production - China

9. 1 year warranty.

Nodes:

Specifications:

TABLE OF CORRESPONDENCE

(Maximum allowable thicknesses)

When working with max. sheet thickness - the maximum parameters may not correspond to the tabular values, this is due to the difference in the ultimate strength coefficient σв, which should not exceed the σв <400 MPa parameter (1 N / mm² = 1 MPa) when working with low-carbon steel.

Cross-section of the clamping beam of the machine to the W2.5 machines